Taping machine LIS-10

The machine works in an XYZ Cartesian coordinate system. It has two taping heads, primarily designed to isolate bars of the largest generators, while also allowing to isolate smaller-size bars by executing a quick replacement on the second head.

In order to wrap better, the Vacuum Pressure Impregnation technology has been applied to this machine while two powerful Forstoff fans are used for resin-rich tapes heating. In addition, LIS-10 has made it possible to produce each machine in accordance with the customer requirements under the precondition of high quality. The life cycle of LIS-10 series is no less than 12 years with continuous intensive working.

Below are the technical data of LIS-10-2018.

Features

- 7 Servo axis;

- 2 Delivering taping heads ;

- HMI OMRON NB7W-TW01B;

- Radio Modem interface from system box to taping head rotor;

- Control panel on taping head rotor for working without modem interface;

- Rings with carbon brushes for rotor energy feeding;

- Stepping motors for tape roll angle changing;

- Automatic change of tape rolls angles if opposite direction starts;

- Tape tension microprocessor system;

- Tape breaking control microprocessor system;

- An adjustable position of dynamic bar holders ;

- End holders controlled by microprocessor;

- Scanner.

HMI main operating options

- Selection of Program;

- Suspension of Program: at any point & Choice of Direction: forward or backward;

- Set of Tape tension value;

- Set of Tape roll angle value;

- Change of Programmed overlapping;

- Set of Manual operation.

LIS-10-2018 general technical data

- Dimensions: L=15.0 m; B=3.6 m; H=3.4 m

- Coordinate system dimensions: X=11800 mm; Y=1600 mm; Z=400 mm

- Bar length: 11.5 m

- Power: 3 ̴ 380 V, 10 kW

Dynamic holders

The travel time between bottom position and top position is around 1-2 s.

The force in top position is more than 2500 N.

The holder is fixed in the top position, even if the power broke off.

The number of holders has to be 8 if the bar length is 10…11.5 m.

End holders

The left end holder has motors to correct its Y and Z coordinates. Coordinate X=0 is constant.

The right end holder has motors to correct its X, Y and Z coordinates. It is equipped with laser rangefinder to measure the distance between holders. The end holders are both equipped with HMI panel.